Microcement, applied by space and intent.
We install the specific CEMHER Microne system for each surface. Pro, Wall or Outdoor. Prepared and applied for the conditions it lives in. Below is what we install across the Gold Coast and Brisbane.
Floors
We apply continuous microcement floors over existing tile, concrete or screed using the CEMHER Microne Pro System. A seamless, hard wearing surface with no grout lines, suited to open plan living, hallways and entryways.
- , Microne Pro System, 3 to 4mm finished thickness
- , Applied over tile, concrete or screed
- , Aquapur70 two part sealer finish
Bathrooms & Wet Areas
Fully waterproof microcement shower walls, floors, baths and vanity surrounds in the CEMHER Microne Pro System. The system is 100% waterproof in every layer, so it never depends on a sealer alone. A monolithic finish that removes tile, grout and the maintenance that comes with them.
- , 100% waterproof in every layer
- , AS 4858 and AS 3740 wet area compliant
- , Continuous wall to floor detail
Walls & Facades
Feature walls, full room finishes and external facades in the CEMHER Microne Wall System. A 1 to 2mm hand trowelled finish that reads beautifully under raking architectural light.
- , Microne Wall System, 1 to 2mm
- , Internal walls, ceilings and feature walls
- , External facades, A+ air quality
Benchtops
Microcement kitchen islands, vanities and joinery tops in the Microne Pro System with the depth of stone and the continuity of a single pour. We seal them with Aquapur70 for everyday use.
- , Kitchen islands and vanities
- , Seamless return edges
- , Aquapur70 sealed for daily wear
Commercial Spaces
Retail, hospitality and workplace fit outs that need large continuous surfaces with minimal downtime. The optional Microne Plus dual component hardener adds compressive, impact and wear resistance for high traffic environments.
- , Retail, hospitality and workplace
- , Microne Plus hardener for high traffic
- , Programmed around site trades